The combined bushhammering-trimming machine allows to effect the longitudinal bushhammering and side trimming of the material in the processing line. The structure is composed of a strengthned electro-welded plate basement with a special covered belt to permit the cut of the disc on it and by two fixed bridges, where the bushhammering spindle and the mobile operating heads are installed.

The switch board is made of sheet steel with 15/10 thickness and IP 55 protection level.

Get a Quote

2 to 3 Units of Cut

  • length mm 5000
  • useful width of cut mm 610
  • maximum thickness of cut mm 45
  • diamond disc diameter mm 350
  • operating head motor power kW 5,5
  • belt forwarding motor power kW 1,1
  • belt forwarding speed m/min 1-5
  • number of revolutions disc motor marble 2800  granite 1900

1 Bushhammering Unit

  • useful bushhammering width mm  400-600
  • bushhammering spindle double speed motor power kW 7,5/11
  • water consumption l/min 35
  • total installed power kW 23,10


  • bushhammering plate Ø 400 – 10 rolls with 16 tools
  • bushhammering plate Ø 600 – 18 rolls with 16 tools
  • motorization and visualization of cutting units movement
  • possibility of single heads pneumatic exclusion

Scratching Unit – Mod. GBV/600

The scratching unit allows to scratch in line strips of marble or stone by means of a roll covered with tools with special steel points (included in the supply).

  • useful scratching width mm 610
  • maximum working thickness mm 80
  • roll motor with revolution number variation  controlled by inverter kW 5,5
  • roll stroke with possibility of variation by means of inverter kW 1,1
  • visualization of roll up-down motor kW 0,35
  • exhaust fan for dust kW 0,75
  • possibility to change stroke width by means of an eccentric mechanical device
  • water consumption l/min 35
  • total installed power kW 7,7